Painless Performance Digital Power Manager With Jump Start, (500-AMP)

The Digital Power Manager with Jump Start (500 amp) includes a weatherproof solid state dual battery control unit that automatically engages an auxillary battery when an approximately 250 amp load is applied to the vehicle's main battery. In addition to this, for added amperage capacity a 250 amp solenoid is included with a momentary push button switch to be mounted in a location that is reachable when turning the ignition key to start the vehicle. This will allow for jump starting the vehicle by momentarily combining the vehicles two batteries. The unit will not allow the electrical loads on the vehicle's main start battery to drain the auxillary battery resulting in a stranded situation for the driver. When the main battery is too low to crank the engine by itself, the Digital Power Manager in combination with the Jump Start solenoid will combine the auxillary and main batteries to crank the engine. Once the engine is running and spinning the alternator again, it will only allow charging of the auxillary battery after the main battery is fully recharged by the alternator.

This solid state dual battery controller eliminates any second guessing when using a secondary battery in any vehicle with a 12 volt system. The system is capable of switching up to 500 amperes of DC current for large loads such as winches or even when jump starting another vehicle. Ideal for any vehicle equipped with high power stereo systems, high amp driving lights or winches.. Included in the kit is the weather proof Digital Power Manager, 250 amp Jump Start solenoid, momentary push-button switch, 6 gauge connection cables, terminals, heat shrink, mounting hardware and a remote indicator light.