Warrior

Home> Warrior Products> Sideplates & Rear Corners

Sideplates & Rear Corners by Warrior Products

1976-1986 Jeep CJ7


Rear Corners have a material thickness of 1/8", provide structural support to the corner area and enhance the appearance of your Jeep CJ7. To allow easier installation, corners have precut holes for the gas tank and tail light openings. Available in four exterior finishes, these corners are long lasting and durable. Sold in pairs. Note: Rear corners will not fit Renegade and/or Sahara Wrangler trim packages, nor Aftermarket fiberglass bodies.



Back to Top


Back to Top

Sideplates protect the rocker panel area below the door and enhance the appearance of the vehicle too. Available flat or with a 90-degree bend (lip) that wraps under the rocker panel 1". Sideplates are sold in pairs. Notes: Sideplates will not fit Renegade and/or Sahara Wrangler trim packages, nor Aftermarket fiberglass bodies. In addition, Sideplates can be ordered without its front section cutout by placing an “X" behind the part number; i.e. #913X. The front edge must then be cut to fit any fender well treatment.



Back to Top


Back to Top


Back to Top


Back to Top

 
  Loading...