- Sold as a kit
- ONLY for off-road use
- Bull Bars with a 76.1mm Tube Diameter
The ARB 20" Intensity AR40 Series Spot Beam LED Light Bar Kit is a heat sink and light bar mounting system designed to improve light bar stability and driving vision. The spot beam pattern produces a very strong single beam down the road with narrow improvement to peripheral illumination. The mounting kit attaches the light bar to the top tube of all bull bars with a 76.1mm tube diameter. It secures to the vehicle using unique tamper-proof security fasteners. The large aluminum extrusion body acts as a heat sink that draws heat generated from the light bar away from the LED array. This increases efficiency and the life of the LEDs. This watertight and dust-proof sealed light bar has been given an IP68 rating for protection against dust ingress and submersion up to 3 meters. This is thanks to a unique molded rubber seal that sits between the polycarbonate lens and cast aluminum body. The 3.5mm injection-molded polycarbonate and hard-coated lens provides scratch and UV-resistance. The cast aluminum body is built from corrosion-resistant materials and comes in a textured polyester powdercoat finish. The wiring loom includes a waterproof Deutsch plug, surface mount switch with LED indicator, and a heavy-duty 30 amp relay. Also available is an 16' extension wiring loom if you plan on mounting this light bar in further-to-reach locations that is sold separately.
- Features two rows of 20 individual LEDs
- 10 degree spot lens/reflectors
- Indestructible polycarbonate lens
- Body is made from cast aluminum
- Engineered in Australia
- Made in the USA
- (1) ARB 20" Intensity AR40 Series Spot Beam LED Light Bar
- Bull Bar Mount - 76.1mm
- Wiring Loom
- A replacement ARB Intensity AR40 Series Wiring Loom, ARB-3500810, is available for purchase.
- The ARB Intensity AR40 Series 16' Wiring Loom Extension, ARB-3500820, gives you the extra length needed to mount a light bar in further-to-reach locations.
- The ARB Driving Light Security Locknut Set, ARB-DLSP10 (10mm) or ARB-DLSP12 (12mm), provide additional protection to your ARB Intensity Light Bar.