At Bartact and Bull Strap, We Use Only Heat-Treated 4130 Chromoly End Pieces And 100 percent Made In Usa Mil-Spec Resin Treated 7,000 Lb Nylon Webbing In A Full Quad Wrap Configuration, So You Have 2 Full Layers Around Each Buckle.
We Don't Skimp On Quality...Ever! Made From 4 Layers Of 7,000 Lb Webbing (28,000 Lb Strength Total, But Load Limit Due To Thread Stress Is Approximately 14,500 Breaking Strength)
With Heavy Duty Enamel-Coated Heat-Treated 4130 Chromoly Hardware, And High Grade Nylon Thread, Bull Strap Limit Straps Are Made To Last And To Hold Up Much Better Than Flimsy Single Or Sound Layer Straps With Hardware Not Even Half The Strength. Beware! Bull Straps are Race Proven By Best In Class Off-Road Racers For Over 14 Years!
Other Made In China Straps Have Copied Our Stamp With The 4130 Heat Treated, But Those End Pieces Break At Roughly 5,500 Lbs. Ours Buckles Are Rated For Over 12,500 Lbs, But Consistently Hold Up To Over 15,000 Lbs In Testing Before Breaking.
Bull Strap (A Division Of Bartact) Straps, Ropes, Bags, and Tie Downs Are The Highest Quality and Top-Of-The-Line In The Off-Road Industry And Are Proudly Made In The USA. We Make Sure To Use Top-Rated Hardware And Webbing, And Refuse To Use The Cheap Stuff...So You Can Say Goodbye To Your Cheap Limit Straps And Upgrade To Ours.
When Ordering, Length Of Strap Is Distance Between Center Of Hole To Center Of Hole. Nylon Is Meant To Stretch Slightly To Keep A Smoother Transition. Strap Stretch Depends On Multiple Variables, Including Weight, Wet Conditions, Etc, But On Most Applications, You Should Factor Roughly An Inch Of Stretch For Every Foot Of Strap.
