Painless Performance Trail Rocker Accessory Control System with Non-Auto Dimming Mirrors - Black by Painless Performance

The Painless Performance Trail Rocker Accessory Control System allows you to control up to eight accessories in your Jeep Wrangler JK. This kit includes six pre-wired switches mounted to the overhead panel using existing mounting holes. The power center mounts under the hood using the included mounting bracket and comes with 200 amps of fused protection. Included is all high-quality TXL output wiring. The switch panel comes in a black finish that matches the interior of your Jeep perfectly.

Inside the panel are 8 fuses and relays. While the panel only comes with six total switches, the two extra circuits allow you to double-up on dual high amp systems. The 200 amp MIDI fuse comes pre-installed and pre-wired. This system includes dedicated wires for controlling a winch, although an additional purchase is required for operation. The underside of the relay cover has a built-in gasket to help keep any moisture away from the relays.

This kit comes with everything needed to install the Trail Rocker Accessory Control System except the tools needed for installation and the Jeep itself. This includes 21' of wire to reach any 12 volt accessory. Printed every 12" on the wire you'll find the circuit description. The harness attaches the fuse & relay center to the switch panel. Included is a custom powdercoated mounting bracket and stainless steel hardware that installs into existing holes under the hood. Its a plug-n-play design that only requires you to route it and plug it in. Also included are custom pigtails that allows the Trail Rocker to power up only when the key is turned on.