sPOD Swicth Panel 8 Circuit Source SE with Touchscreen for 97-06 Wrangler TJ

sPOD systems utilizes automotive grade approved high-power, high-temp, ultra-reliable components with a maximum 100 amp capacity! The sPOD SourceSE is a Solid-State fully programmable digital CAN-Bus controlled system utilizing state-of-the-art technologies. OEM vehicle specific simple installation hardware, engineered and 100 percent manufactured in the United States since 2006.

The touchscreen controller is small but packs a BIG punch! (3-3/4"w X 2-7/8"h X 5/8" thick) The control module is a 3.5" LED backlit TFT LCD screen with a resolution of 320 x 240, 16.7m colors and a viewing angle of 180 degrees housed in a billet aluminum case with a 1" RAM mount installed on back panel. The connection between the SourceSE and the touchscreen uses a standard Ethernet cable 10 feet long.

Benefits:

• Reduced installation time and labor allowing for mounting and connection of eight switches at one time versus individually.


• Reduced wire harness complexity, using one harness to our controller to accommodate up to 32 circuits.


• Reduced harness size offers an overall reduction in weight, improving operational efficiency of the equipment.


• Increase in switch lifecycle over traditional electromechanical switches.

Each switch is programmable for:

• Dimming


• Strobe


• Flash


• Momentary


• Switch Linking


• On Road and Off Road mode of operation

Touchscreen Control Module Features:

• Voltage feedback (vehicles battery/alternator voltage)


• SourceSE board temperature feedback (shown on screen)


• Customization: legends (3 lines of text)


• Automatic backlighting off after 30 minutes of being inactivity


• Automatic power off after 6 hours of being inactive or engine not running (Deep sleep mode)


• One touch off function


• One second hold on off button shuts all circuits down


• Automatic system shut down when touchscreen is unplugged


• Backlight dimming


• Multiple Source select (One touchscreen can control up to 32 circuits)

Optional Recommended Equipment:

• RAM-201U Double Socket Arm for 1 inch RAM Ball (Must have this in order to mount touchscreen)


• RAM-238U Base with 1 inch RAM Ball (For fixed surface mounting and interconnect between double socket arm)


• 8-700-PSA A-Pillar Mount with 1 inch rubber coated Ram Ball. (For fixed surface mounting and interconnect between double socket arm)


• RAM-224-1U Suction Cup Base with 1 inch RAM Ball (For fixed surface mounting and interconnect between double socket arm)


• 8-700-BT Add-on Bluetooth module to enable the system to be controlled by an iPhone, iPad or iPad Mini (Optional)