Yukon Pinion install kit for Dana 44 differential, 19 spline

Yukon Pinion install kit for Dana 44 differential, 19 spline. Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings & races can be reused. This kit uses Timken bearings and races along with a high quality pinion seal and small parts. Included in this kit are the pinion bearings and races, pilot bearing (if applicable), crush sleeve (if applicable), complete pinion shim kit, pinion nut, thread locker, and marking compound with brush. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your pinion gear.

Compatible Differentials
Dana 44, 19 Spline

Compatible Jeep / Model
Jeep Commando (1966 - 1973)

Other Compatible Make / Model
Ford E-150 1/2 Ton (1975 - 1979)
Ford F-100 1/2 Ton (1948 - 1969)
Ford F-250 3/4 Ton (1959 - 1965)
Jaguar Mark I (1955 - 1959)
Jaguar Mark II (1950 - 1970)

Years Covered:
1966, 1967, 1968, 1969, 1970, 1971, 1972 and 1973